Assembling the handlebar and front wheel

KEEP CHILDREN AWAY WHILE ASSEMBLING

1. Use an Allen wrench to loosen the handlebar clamp. (See Figure 2)
2. With the clamp facing the back, insert the handlebar into the fork tube at the desired height. (See Figure 3 and 4) Note the minimum insert line on the handlebar tube.
3. Use an Allen wrench to tighten the binder clamp completely. (See Figure 5) The handlebar should be held firmly in place.
4. To fit the front wheel, turn the Mini Mix balance bike upside down so that it rests on the saddle and handlebar. Align the front wheel between the front fork ensuring that the wheel rotation direction matches the rear wheel. (See Figure 6)
5. Insert the screw into the hole on one side of the fork, and tighten it completely with a 5mm Allen
   wrench. (See Figure 7) Repeat it for the other side. Make sure screws are tightened securely.

Assembling the saddle

Check for the correct saddle height by having your child sit on the saddle. Proper saddle height should allow your child to sit on the bike with both feet flat on the ground with a slight bend in their knees (See Figure 8). The correct saddle height is essential for proper functioning. Check and adjust the saddle height periodically.

1. Identify the seatpost clamp under the saddle and loosen binder clamp with the 5mm Allen wrench. (See Figure 9)
2. With the clamp facing the back, raise/lower the seat to the desired height. (See Figure 10 and 11)
3. Tighten binder clamp with the 5mm Allen wrench. (See Figure 12)
4. Push and pull on the saddle to make sure it is secured.